CB650SC/New Owner Suggestions

Should replace

O-rings

Avoid fuel leakage:

• Carb "Tee" x2
• Carb bowl x4
• Carb flow tubes & vent "Tees" x8(x4+x4)

Avoid Air leakage(leads to lean):

• Carb-head x8

Avoid low head/cam/tappet lubrication:

• Valve-train oil pipe x10(x2+x8)

Avoid low oil pressure/dirty oil contamination?:

• Oil filter tube x3?
• Oil filter cover x1 (sometimes comes with new filter, can be reused carefully)

Must clean/rebuild

Carburetors

• Check and replace with same jets & emulsion tube or clean, check, and reuse (order individually by size, no kits)
• Reuse main-jet needle (do not trust "kits")
• If a po crushed the mixture screw seats, tuning will go from 2-3 turns out to something like 1/4-3/4 of a turn out
  • The hole that the very tip of the mixture screw "needle" goes into should have a narrow, raised "lip" surrounding it. If you look down the mixture screw hole, and see a "pin-hole" that is flush to the base or has "started" out metal around it that looks like a pressed rivet, the screw seat is crushed and destroyed.
• It goes without saying, vacuum-balance the carbs
  • Nothing beats digital gauges for speed, ease of use, or accuracy.

Hydraulic Tappets

• Follow manual for removal
• Use allen key (my recommendation), smooth bore side of 1/16 drill bit (Clymer manual), or special tool Honda 07973-ME9-0000 to bleed out oil
• again bleed upright under kerosene (mineral spirits or maybe even diesel fuel in a pinch?) to clean
• bleed out the solvent from the last step
• bleed under engine oil until primed (pushing on the taper without the "bleeder pin" should feel like it is basically completely solid
• keep upright and install with the tappet lower hole toward the (toward spark-plugs) squirter?