DSM/ECU/Reverse Engineering

Toolbox

• DSLR
• Screwdrivers
• Tweezers
• Solder
• Solder Sucker
• Solder Wick
• Soldering Iron
• SMD/Reflow Air Tool
• Chamois cloth

Solvents

• Acetone
• WD-40
• Flux
• Flux cleaner
• H20

How-To

Hardware

1. Obtain ECU
2. Take external photographs
   • Mostly for all the numbers and letters/the stickers
3. Open ECU
4. Remove PCB
5. TAKE MORE PICTURES (before you touch anything else)
   • The code on the plug socket
   • The microprocessor
   • The EPROM (if there is one)
   • Any and all visible marking on components
   • The ENTIRE board on BOTH sides
6. RECORD all components with visible markings, decode resistor values
   • This means a table with the PCB Silkscreen references and the components values
7. ACETONE bath
   • This is to remove all the conformal coating junk that interferes with reading markings AND the ability to probe, test, and desolder
8. SCRUB with Toothbrush, Q-Tips
9. PHOTOGRAPH and RECORD any newly visible information
10. REMOVE any components with known values:
    1. Electrolytic capacitors can go first
    2. Then any ICs
    3. Resistors with the bands already decoded
    4. Connectors
11. REMOVE components with unknown values ONE AT A TIME
    1. SMD Capacitors and Transistors are good examples
    2. Remove one, use the Multimeter and/or LCR meter to get values and RECORD them in the table
12. Eventually you will be left with a BARE BOARD
13. SPRAY and WIPE DOWN the bare PCB with WD-40 to clean up any remaining conformal coating and junk
    • This preps the board for nice clear photographs
14. PHOTOGRAPH both sides of the PCB
    • Get ONE photo of EACH side of the PCB
    • Flat
    • In focus
    • Dead-on photos with no perspective error
    • Use a tripod
    • Use lighting
    • Use a remote shutter-release to eliminate shake from the image